Journal of Electrical Engineering and Electronic TechnologyISSN: 2325-9833

Reach Us +1 850 754 6199
All submissions of the EM system will be redirected to Online Manuscript Submission System. Authors are requested to submit articles directly to Online Manuscript Submission System of respective journal.

Research Article, J Electr Eng Electron Technol Vol: 6 Issue: 4

A Solution for the Breakage of the Feedback Wires from the Fast-Moving Robotic Arms

Tarun G Maddila*

Maddila TG, Electrical and Electronics, PSG College of Technology, Coimbatore, India

*Corresponding Author : Maddila TG
Electrical and Electronics, PSG College of Technology, Coimbatore, India
Tel: +91-9566653696
E-mail:
[email protected]

Received: August 30, 2017 Accepted: October 17, 2017 Published: October 24, 2017

Citation: Maddila TG (2017) A Solution for the Breakage of the Feedback Wires from the Fast-Moving Robotic Arms. J Electr Eng Electron Technol 6:4. doi: 10.4172/2325-9833.1000151

Abstract

This paper is a research work done at Ford India Private Limited Chennai. The current and voltage feedback wires from the robotic spot (adaptive resistance) welding arm to the welding controller often gets cut off due to the fast multi axial rotational motion of the arm. This problem not only exists in Ford India Private Limited Chennai but also in most of the automotive industries in the country. This paper proposes a solution to this problem by a detailed study and a stepwise approach to the same. The entire wiring system was replaced with a wireless system. This wireless protocol is selected in such a way that there is no noise that affects the data that is transferred. Therefore, this solution will reduce the down time which will lead to more profit for the industry.

Keywords: Adaptive welding; Breakage of wires; Feedback-wires; Wireless communication

Track Your Manuscript

Share This Page